Enable-IT 850 CPE User Manual download pdf (Page 2)

INSTALLING THE 850 CPE ETHERNET EXTENDER

Installation

The Enable-IT 850 CPE Extended Ethernet Units have a distance restriction of 8,000ft or

2,440m over 1-pair of Category 2 up to Category 5e / CAT6 wiring from device extension

to device extension.

 Total distance limitation of 8,000ft or 2,440m from end to end.

 1 Pair CAT-2 wiring or 4-pair Cat5e .30 Gage or better cabling is required.

For the Interlink port use an RJ-11 connector. Crimp a RJ-11 Male Head to each

end of the contiguous wire run and using the following pins (1 & 2) straight through.

This will deliver 1 Voice line, 100Mbps Full Duplex Ethernet Data.

Perform an out of the box Test (OOTBT)

We highly recommend a quick test to ensure the working order of you 850 CPE

units. To do this, please use one of the Telephone patch cords provided and

attach to the 850 CPE Interlink port and then to the 8950 DSLAM Interlink port.

Power up both 850 CPE units and the 8950 DSLAM Concentrator. The Green Sync

LEDs will start flickering slowly and then fast as the units talk to each other. After

a few seconds you should see a solid Green Interlink Sync LED on each 850 CPE

unit to confirm a link is established. The 8950 DSLAM will take about 30 seconds

to startup then link will be established with the 850 CPE. This confirms basic

proper operation of the units. Next for a more detailed test and to confirm your

LAN Equipment works with the 850 CPE, connect your Ethernet LAN to the 8950

DSLAM and remote device to the 850 CPE LAN ports and test connectivity. The

Green Interlink Sync LED will pulse rapidly as it detects traffic.

1 2 3 4 5 6

No comments

Enable-IT 850 CPE User Manual Page 2